TEC2000: The new non-intrusive actuator that brings Total Electronic Control down to earth.
 |
RDMs ensure controls are easy to reach ... even when the actuator isn’t!
EIM’s exclusive Remote Display Module (patent pending) puts the TEC2000’s non-intrusive controls within easy reach, no matter where the actuator is installed. You can network two remote control modules up to 4,000 feet (1.2 km) away and perform all of the same configuration and diagnostic tasks that can be accomplished on the actuator’s local controls. The RDMs may be powered from either the actuator’s 24VDC power supply or independent 115/220VAC power source. (Requires only four wires for both power and communication!) Whether the actuator is mounted far away or up high, the RDM conveniently brings control of the TEC2000 “down to earth”… right to the operator’s level.
The handwheel that’s not a wheel.
TEC2000’s gear box uses reduction gearing to reduce the effort needed to manually open or close a valve. Its distinctive “fold-up” spinner handle provides a compact profile and keeps the handle safely out of the way until it’s needed. (Patent pending.)
Effortless declutching!
Another practical innovation: shift to manual operation with minimum effort! No “cheater” bar is needed— even on tightly sealed valves. The lever can also be padlocked for safety in either Hand or Motor position.
Tri-Set design gives you three setup choices.
Configure the actuator in any of three ways:
- selector switches on the unit’s Local Display Module;
- CE Windows PC or PDA device;
- the Clicker, a key-chain sized IrDA controller.