Slow Pulse Input Source and Isolated Modules
The Slow Pulse Input Source and Slow Pulse Input
Isolated Modules plug into a ROC 300-Series Remote Operations Controller, or a FloBossTM 407 Flow Manager, and count the changes in the status of relays, solid-state switches, or other two-state devices.
Each module accommodates one pulse input.
Isolated Modules plug into a ROC 300-Series Remote Operations Controller, or a FloBossTM 407 Flow Manager, and count the changes in the status of relays, solid-state switches, or other two-state devices.
Each module accommodates one pulse input.
The modules provide an LED to show when the input is active and use a scaling resistor for scaling the input
range. Functions supported (for example, raw pulse accumulation, rate in EUs, today’s total in EUs) are controlled by the ROC or FloBoss firmware.
The source module provides a source voltage for dry relay contacts or for an open-collector solid-state switch.
The isolated module accepts an external voltage from a powered two-state device, while maintaining electrical isolation from the ROC or FloBoss power supplies.
Connections between the modules and field wiring are made through separate terminal blocks, which plug into the ROC or FloBoss. This facilitates removal and replacement of modules without disconnecting field wiring.