V-CONE METERING USER PROGRAM
 |
1.1 ORGANIZATION OF MANUAL
In this manual, the sections are arranged to provide information in the order in which it is required for first-time users. Once you become familiar with the procedures and the software running in a ROC, the manual may be used as a reference tool.
This manual is organized into the following major sections:
- Section 1 - Introduction
- Section 2 - Downloading the Program
- Section 3 - Configuring the Program
1.2 PROGRAM REQUIREMENTS
The V-Cone Metering User Program is downloaded into and run from User Program memory located in a ROC809 unit.
Requirements for the User Program:
- ROC809 Firmware version 1.25 or greater must be installed (check by using ROCLINK 800 to look at “Other Information” display under “Information” under the “ROC” menu).
- ROCLINK™ 800 Configuration Software, Version 1.23 or greater (check by using the About function in the Help menu of ROCLINK 800).
- A hardware based License Key is required to activate the orifice meter points. Either 6 or 12 meter runs may be licensed for a given unit. Refer to the ROC809 Remote Operations Controller Instruction Manual (A6116) for instructions on installing the License Key.
- A hardware based License Key is required to enable the V-Cone user program. Refer to the ROC809 Remote Operations Controller Instruction Manual (A6116) for instructions on installing the License Key.