GAS CHROMATOGRAPH USER PROGRAM
 |
1.1 ORGANIZATION OF MANUAL
In this manual, the sections are arranged to provide information in the order in which it is required for first-time users. Once you become familiar with the procedures, and the software running in a ROC, the manual may be used as a reference tool.
This manual is organized into the following major sections:
- Section 1 - Introduction
- Section 2 - Downloading the Program
- Section 3 - Configuring the Program
1.2 PROGRAM REQUIREMENTS
The Gas Chromatograph User Program is downloaded into and run from User Program memory located in a ROC809 unit.
Requirements for the User Program:
- Firmware version 1.21 or greater must be installed (check by using ROCLINK to look at “Other Information” display under “Information” under the “ROC” menu).
- ROCLINK 800 Configuration Software, Version 1.10 or greater (check by using the About function in the Help menu of ROCLINK).
- EIA-232 (RS-232) port on the CPU, EIA-232 (RS-232) communications module, or EIA-485 (RS-485) communications module.
- A hardware based License Key is required to enable the user program. Refer to the ROC809 Instruction Manual (A6116) for instructions on installing the License Key.
The downloadable program name is GcInterface.tar.